Paper
30 June 2016 Process control for centering of cemented components
Markus Lipp
Author Affiliations +
Proceedings Volume 10009, Third European Seminar on Precision Optics Manufacturing; 1000913 (2016) https://doi.org/10.1117/12.2235173
Event: Third European Seminar on Precision Optics Manufacturing, 2016, Teisnach, Germany
Abstract
Actual optical systems have increasing requirements on accuracy and cost reduction at the same time. This leads to high demands for the process control during production. For high precision lenses it is not unusual that centering accuracies of single lenses and mounted components are the limiting tolerances for the overall system performance. At the same time it is important that also for less demanding systems the most cost efficient production process can be identified. By applying sensitivity analysis methods, typically used in optical design, it is easy to achieve a deeper understanding of the centering process of cemented components. The relevant centering parameters and their respective sensitivity can be calculated for different manufacturing methods and the optimum overall process can be chosen by comparison.
© (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Markus Lipp "Process control for centering of cemented components", Proc. SPIE 10009, Third European Seminar on Precision Optics Manufacturing, 1000913 (30 June 2016); https://doi.org/10.1117/12.2235173
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Cements

Lenses

Process control

Tolerancing

Error analysis

Optical alignment

Received signal strength

RELATED CONTENT

Tolerancing model for better prediction
Proceedings of SPIE (September 14 2023)
Group error modeling in optical tolerancing and alignment
Proceedings of SPIE (August 11 2020)
New approach to cost-based tolerancing
Proceedings of SPIE (November 26 2012)
Evaluating device design rules based on lithographic capability
Proceedings of SPIE (September 14 2001)
Automatic centring and bonding of lenses
Proceedings of SPIE (May 14 2007)

Back to Top