Paper
14 October 2021 Design of DC filter for 24-pulse high power rectifier
Zhuo Ling
Author Affiliations +
Proceedings Volume 11930, International Conference on Mechanical Engineering, Measurement Control, and Instrumentation; 119302P (2021) https://doi.org/10.1117/12.2611604
Event: International Conference on Mechanical Engineering, Measurement Control, and Instrumentation (MEMCI 2021), 2021, Guangzhou, China
Abstract
Conventional high power rectifier with 24 pulse output usually uses flat wave reactor in the DC side to suppress the ripple contained in the output waveform, so that the output DC is close to the ideal DC. Although this method has good economic benefit, the filtering effect is not good. Firstly, the necessity of installing DC filter is analyzed from the harmonic component. Secondly, according to the impedance-frequency characteristic equation, the parameter calculation formula of the double-tuned filter is deduced. Finally, the ideal output waveform of the main circuit is obtained through Matlab/Simulink simulation, and the feasibility of filtering specific sub-harmonics by the double-tuned filter is preliminarily verified by FFT analysis, and the ideal filtering effect is obtained.
© (2021) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Zhuo Ling "Design of DC filter for 24-pulse high power rectifier", Proc. SPIE 11930, International Conference on Mechanical Engineering, Measurement Control, and Instrumentation, 119302P (14 October 2021); https://doi.org/10.1117/12.2611604
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Resistance

Device simulation

Power supplies

Capacitors

Transformers

Absorption filters

Phase shifts

Back to Top