Paper
25 January 2012 Dispersion and dispersion slope compensation impact on high channel bit rate optical signal transmission degradation
Mahamadou Hamidine, Xiuhua Yuan
Author Affiliations +
Abstract
In this article a numerical simulation is carried out on a single channel optical transmission system with channel bit rate greater than 40 Gb/s to investigate optical signal degradation due to the impact of dispersion and dispersion slope of both transmitting and dispersion compensating fibers. By independently varying the input signal power and the dispersion slope of both transmitting and dispersion compensating fibers of an optical link utilizing a channel bit rate of 86 Gb/s, a good quality factor (Q factor) is obtained with a dispersion slope compensation ratio change of ±10% for a faithful transmission. With this ratio change a minimum Q factor of 16 dB is obtained in the presence of amplifier noise figure of 5 dB and fiber nonlinearities effects at input signal power of 5 dBm and 3 spans of 100 km standard single mode fiber with a dispersion (D) value of 17 ps/nm.km.
© (2012) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Mahamadou Hamidine and Xiuhua Yuan "Dispersion and dispersion slope compensation impact on high channel bit rate optical signal transmission degradation", Proc. SPIE 8331, Photonics and Optoelectronics Meetings (POEM) 2011: Optical Communication Systems and Networking, 83310M (25 January 2012); https://doi.org/10.1117/12.917288
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Dispersion

Optical fibers

Single mode fibers

Scanning probe microscopy

Channel projecting optics

Transmittance

Optical amplifiers

Back to Top