1 January 2010 Wear-ratio-based tool wear compensation for microelectrodischarge-machining of silicon through process simulation
Author Affiliations +
Abstract
A prototype microelectrodischarge machine (micro-EDM) with a piezoactuated tool feed mechanism has been developed. In micro-EDM, the tool also experiences continuous wear during machining. This necessitates a tool wear compensation technique to attain a specified depth of micromachining on the workpieces. Tool wear compensation studies are performed during micromachining of silicon wafers using a copper tool. In order to estimate the necessary tool wear compensation, an axial tool wear and micromachined hole-depth measurement technique is incorporated, and variation in wear ratio at different depths of micromachining is investigated. Process simulation of micro-EDM is also performed to estimate the tool wear compensation required to reach a predefined depth during micromachining on silicon. Results obtained by simulation for the required tool feed, depth of hole achieved corresponding to a set value, and the resulting axial tool wear are in close agreement with experimental results. A machining depth variation of about 6% with respect to the estimated depth is observed. This approach provides a process control methodology for mircromachining of semiconductor and conducting materials to predefined depth with high accuracy.
©(2010) Society of Photo-Optical Instrumentation Engineers (SPIE)
Muralidhara Rao, Nilesh Jayantilal Vasa, and Makram Singaperumal "Wear-ratio-based tool wear compensation for microelectrodischarge-machining of silicon through process simulation," Journal of Micro/Nanolithography, MEMS, and MOEMS 9(1), 013040 (1 January 2010). https://doi.org/10.1117/1.3280262
Published: 1 January 2010
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Silicon

Micromachining

Semiconducting wafers

Copper

Process modeling

Prototyping

Control systems

RELATED CONTENT

Automotive sensors
Proceedings of SPIE (January 16 2003)
Adaptive process control for a rapid thermal processor
Proceedings of SPIE (April 01 1991)
Advanced process control system for vertical furnaces
Proceedings of SPIE (September 13 1996)

Back to Top