28 August 2014 Laser microwelding of thin Al layers for interconnection of crystalline Si solar cells: analysis of process limits for ns and μs lasers
Henning Schulte-Huxel, Susanne Blankemeyer, Sarah Kajari-Schröder, Rolf Brendel
Author Affiliations +
Abstract
We investigated a laser welding process for contacting aluminum-metallized crystalline silicon solar cells to a 10-μm-thick aluminum layer on a glass substrate. We analyzed the threshold for laser-induced damage in dependence on the solar cell metallization thickness by applying the process on SiNx passivated lifetime samples. In addition, we measured themechanical failure stress of the laser welds by perpendicular tear-off. We applied two types of laser processes; one used single or multiple 20-ns-laser pulses at 355 nm with fluences between 12 and 40 J∕cm2, and the other used single 1.2-μs-laser pulses at 1064 nm with 33 to 73 J∕cm2. The ns-laser pulses were able to contact down to 1-μm-thick aluminum layerson silicon without inducing laser damage to the silicon and led to a sufficiently strong mechanical contact. In the case of μs-laser pulses, the limiting thickness was 2 μm. Both laser systems were compared and discussed with respect to the theory of laser-induced forward transfer. Theapplication was shown by contacting solar cells with 2-μm Al metallization on the rear side using μs-laser pulses proving a damage-free contacting.
© 2014 Society of Photo-Optical Instrumentation Engineers (SPIE) 0091-3286/2014/$25.00 © 2014 SPIE
Henning Schulte-Huxel, Susanne Blankemeyer, Sarah Kajari-Schröder, and Rolf Brendel "Laser microwelding of thin Al layers for interconnection of crystalline Si solar cells: analysis of process limits for ns and μs lasers," Journal of Photonics for Energy 4(1), 041597 (28 August 2014). https://doi.org/10.1117/1.JPE.4.041597
Published: 28 August 2014
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
Back to Top