We present a plan for sub/millimeter-wave line intensity mapping (LIM) using an imaging spectrograph based on the Terahertz Integral Field Units with Universal Nanotechnology (TIFUUN) architecture. We aim to measure the dust-enshrouded cosmic star formation rate density within the first 2 billion years by conducting LIM observations of ionized carbon [C II] 158 μm and oxygen [O III] 88 μm lines, redshifted to sub/millimeter wavelengths. The proposed imaging spectrograph will simultaneously observe two frequency bands: Band-1 (139-179 GHz) and Band-2 (248-301 GHz). Each band will feature up to ∼100 imaging pixels (spaxels), with each spaxel having 100 spectral channels, providing a modest spectral resolution (R~500). The total number of detectors (voxels) will reach ~20,000. This dual-band configuration will allow simultaneous measurement of key spectral lines, e.g., [C II] 158 μm and [O III] 88 μm lines at z = 10.2 - 12.6, and CO(4-3), (7-6), [C I](1-0) and (2-1) at z = 1.9 - 2.2, enabling cross-correlation analysis. We will develop data-scientific methods to remove atmospheric noise using sparse modeling and to extract signals from the observed data using deep learning.
We present the on-sky commissioning and science verification of DESHIMA 2.0: the first science-grade integrated superconducting spectrometer (ISS) for ultra-wideband mm-submm spectroscopy. With an instantaneous band coverage of 205-392 GHz at a spectral resolution of F/dF = 500, DESHIMA 2.0 will be applied to emission line surveys and redshift measurement of dusty star-forming galaxies, spectroscopic Sunyaev–Zeldovich effect observations of galaxy-clusters, and other new science cases that utilize its ultra-wide bandwidth. Compared to its predecessor (DESHIMA 1.0), DESHIMA 2.0’s superconducting filterbank chip with a x4 higher optical efficiency, x4 wider instantaneous bandwidth, x20 faster position switching on the sky, and a remotely-controlled optics alignment system. DESHIMA 2.0 is currently installed on the ASTE 10-m telescope at 4860 m altitude with excellent sky transmission, and is being commissioned for science operation. In the conference we will report the on-sky performance and latest results in the science-verification campaign at ASTE.
The Atacama Large Millimeter/submillimeter Array (ALMA) Wideband Sensitivity Upgrade (WSU) will at least double the observation bandwidth and improve the sensitivity and scientific capabilities. The WSU requires upgrading the receiver front-end and the associated analog and digital electronics including the correlator, as well as the ALMA software. In line with the WSU mission, the National Astronomical Observatory of Japan (NAOJ) initiated the ALMA Band 8 (385-500 GHz) version2 receiver upgrade project, aiming to build an upgrade of the currently existing receiver cartridge with a substantially improved second-generation version. This project originated from significant advances in receiver technologies and a variety of our previous wideband studies in the last decade. This paper briefly summarizes an overview of this project, scientific needs in this frequency range, and the technical readiness and challenges for critical components and subsystems.
Removing sky emission is essential to extract astronomical signals for submillimeter spectroscopy with ground-based single-dish telescopes, however, conventional switching methods not only cause baseline instability but result in low observing efficiency of on-source. Here we present two statistical approaches to efficient sky removal. For a heterodyne receiver, we develop an off-point-less observing method by a frequency-modulating local oscillator (FMLO; Taniguchi et al., PASJ, in press), which is three times more efficient than the conventional method. For an ultra-wideband spectrometer (DESHIMA; Endo et al. 2019a, 2019b), we develop a sky removal method applicable to continuum observations by using an atmospheric model.
We report the current status of the NASCO (NAnten2 Super CO survey as legacy) project which aims to provide all-sky CO data cube of southern hemisphere using the NANTEN2 4-m submillimeter telescope installed at the Atacama Desert through developing a new multi-beam receiver and a new telescope control system. The receiver consists of 5 beams. The four beams, located at the four corners of a square with the beam separation of 720′′, are installed with a 100 GHz band SIS receiver having 2-polarization sideband-separation filter. The other beam, located at the optical axis, is installed with a 200 GHz band SIS receiver having 2-polarization sideband-separation filter. The cooled component is modularized for each beam, and cooled mirrors are used. The IF bandwidths are 8 and 4 GHz for 100 and 200 GHz bands, respectively. Using XFFTS spectrometers with a bandwidth of 2 GHz, the lines of 12CO, 13CO, and C18O of J=1−0 or J=2−1 can be observed simultaneously for each beam. The control system is reconstructed on the ROS architecture, which is an open source framework for robot control, to enable a flexible observation mode and to handle a large amount of data. The framework is commonly used and maintained in a robotic field, and thereby reliability, flexibility, expandability, and efficiency in development are improved as compared with the system previously used. The receiver and control system are installed on the NANTEN2 telescope in December 2019, and its commissioning and science verification are on-going. We are planning to start science operation in early 2021.
We are promoting the Hybrid Installation Project in Nobeyama, Triple-band Oriented (HINOTORI), a project aiming at triple-band simultaneous single-dish and VLBI observation in the 22-, 43- and 86-GHz bands using the Nobeyama 45-m Telescope. The triple-band simultaneous observation becomes possible by developing two perforated plates and mounting them in the Nobeyama 45-m Telescope optics. One is a 22/43-GHz-band perforated plate, which transmits the higher frequency (43-GHz) band and reflects the lower frequency (22-GHz) band, and the other is a 43/86-GHz-band perforated plate, which transmits the 86-GHz band and reflects the 43-GHz band or lower. Both plates are designed to be installed in the large telescope optics with a beam diameter as large as 50 cm and insertion/reflection losses are both 0.22 dB (5%) or less in the design. The receivers used in triple-band simultaneous observation system are the H22 and H40 receivers, which are already installed in the Nobeyama 45-m Telescope, and the TZ receiver, which is a 100-GHz-band receiver including the 86-GHz band and reinstalled in the Nobeyama 45-m Telescope. A system of simultaneous observations in the 22- and 43-GHz bands of the Nobeyama 45-m Telescope with the 22/43- GHz-band perforated plate has been completed and commissioned for scientific observations. Also VLBI fringes between the Nobeyama 45-m telescope with the dual-band observation system and the VERA 20-m telescopes at 22 and 43 GHz was detected successfully.
We present a concept of a millimeter wavefront sensor that allows real-time sensing of the surface of a groundbased millimeter/submillimeter telescope. It is becoming important for ground-based millimeter/submillimeter astronomy to make telescopes larger with keeping their surface accurate. To establish `millimetric adaptive optics (MAO)' that instantaneously corrects the wavefront degradation induced by deformation of telescope optics, our wavefront sensor based on radio interferometry measures changes in excess path lengths from characteristic positions on the primary mirror surface to the focal plane. This plays a fundamental role in planed 50-m class submillimeter telescopes such as LST and AtLAST.
We report the development of the new 4-beam, 2-polarization, 2-sideband, 100 GHz band SIS receiver "FOREST" (FOur beam REceiver System on the 45-m Telescope) and the results from commissioning and observations on the Nobeyama 45-m Telescope operated by Nobeyama Radio Observatory, a branch of National Astronomical Observatory of Japan. FOREST aims to add new capabilities of large-area mapping and simultaneous multi-line observation at 80 { 116 GHz band to the Nobeyama 45-m Telescope, which is one of the largest millimeter radio telescopes in the world. The configuration of the four beams is a quadrate of 2 x 2 with the separation between adjacent beams of 50". Beam size of each beam is ~ 15" at 115 GHz. Receiver noise temperature is as low as that of ALMA Band 3 receivers, so that mapping speed is more than four times as high as that of the other 100 GHz band receivers on the 45-m Telescope. The IF bandwidth is 8 GHz (4 { 12 GHz) realizing simultaneous 12CO(J = 1-0), 13CO(J = 1-0), and C18O(J = 1-0) observations. Cooled components inside of cryostat are modularized per beam. IF signals from the cryostat are processed by the room temperature IF system, and then passed to spectrometers. We have installed the FOREST receiver into the Nobeyama 45-m Telescope, evaluated its performance, and made large area mapping observations. These demonstrate the excellent performance of the FOREST receiver and the Nobeyama 45-m Telescope.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.